Dedenbear's optional Primary Throttle Kit was designed for extremely fast cars and/or engines with huge displacements. In applications demanding E.T. reductions of five-tenths (.5 second) or more, this second set of Bear Stop butterflies and linkage is recommended. Bolt it on in 10 minutes! Unlike similar kits now on the market, Dedenbear's Primary Throttle Kit was developed on a flow bench to maintain an optimum air flow curve. The resulting design effectively adjusts the geometry between the primaries and secondaries throughout throttle travel, much like progressive carburetor linkage. | |
| |
Single acting (air on) retrofit kits replace the electric solenoid on your base plate throttle stop. They allow control over the opening rate of the throttle stop to control tire spin at throttle stop opening. They come complete with cylinder, solenoid and needle valve adjuster. Order in kit form to include the complete AB10K CO2 bottle kit. | |
| |
Dual acting (air on/air off) retrofit kits replace the electric solenoid on your base plate throttle stop. They allow precision control over the opening and closing rate of the throttle stop. They come complete with cylinder, remote solenoid pack and needle valve adjusters. Order in kit form to include the complete AB10K CO2 bottle kit. | |
| |
Retrofit Secondary Shaft Kit After extensive research, Dedenbear has come up with a new secondary throttle shaft for Dominator Bear Stops featuring a unique linkage geometry ratio that creates incredible repeatability when using the Holley Dominator carburetor. All new dominator throttle stops come standard with this linkage. Now you can retrofit your older Bear Stop with this inexpensive bolt-in kit. | |
| |
Spare Solenoids
| |
Premium 4-way Solenoids The same premium 4-way solenoids packaged with every TS6, TS30, TS35, TS1RD and TS5RD are available separately to retrofit any dual acting (air on/air off) cylinder. Designed with consistency and reliability in mind, the SOL4 or SOL5 is a worthwhile upgrade to any air on/air off device. Comes completely assembled and plumbed with mounting bracket, hardware and quick disconnect fittings. The SOL4 has a 1/4" inlet, (1) 1/4" and (1) 3/16" outlet. The SOL5 has a 1/4" inlet, (1) 1/4" and (1) 5/32" outlet. | |