|
|
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
 |
 |
 |
 |
- Bolt in replacement - length and crossmember mounting flange is exactly the same as stock
- Needle roller bearing transfers maximum horsepower
- Triple lip seal
- Spiral retaining ring to prevent bearing walk
- Relocated vent puts an end to the problem of trans fluid spraying out of breather
- Completely pre-assembled
- Includes a hardware kit with everything you need to bolt it on
This
rollerbearing tailshaft housing is designed to fit both the Dedenbear Superglide
and the stock GM Powerglide transmissions. 5 times stronger
than stock, yet weighs only 4-1/2 pounds.
Special Note: No speedometer cable provision is supplied and due to the precise dimension of the needle bearing, some yokes may need polishing to fit correctly. Accepts 1.497" - 1.499" O.D. yokes. Some yokes are produced at 1.502" to compensate for bushing wear. MEASURE YOURS!
Mark Williams Enterprises (800-525-1963) offers a yoke especially made for this housing, properly sized with a hardened wear area. M.W. p/n 39035.
We also stock the yoke, part# PGYMW for $219.00
Strange
Engineering (847) 869-7010 also offers a special Yoke for the Dedenbear
PGH-1 tail housing, Strange
part #U1667N
